8
•
If your traction unit has tires and you have the
agricultural or Sitework Systems tires installed on the
traction unit, remove the tires and move the right side
tires to the left and the left side tires to the right. This
will ensure that the tire tread points to the rear to give
you the most traction when using the vibratory plow.
Maintenance
Service Interval Chart
Service Operation
Each
Use
5
Hours
25
Hours
200
Hours
Storage
Service
Notes
Grease pivot pin fittings
X
X
Gear lube oil—check level
X
Gear lube oil—change
X
Chipped surfaces—paint
X
CAUTION
POTENTIAL HAZARD
•
If you leave the key in the ignition switch, someone could start the engine.
WHAT CAN HAPPEN
•
Accidental starting of the engine could seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
•
Remove the key from the ignition switch before you do any maintenance.
Greasing
Service Interval/Specification
Grease 6 fittings, as shown in Figures 8 through 11, every
8 operating hours. Grease all fittings immediately after
every washing.
Grease Type: General-purpose grease.
Fitting Locations
m–4146
Figure 8
m–4148
Figure 9
