15
3352-864 Rev B
•
Raise the cutting height on your mower.
•
Cut the grass more frequently.
•
Overlap cutting swaths instead of cutting a full
swath with each pass.
•
Set the cutting height on the front wheels one
notch lower than the rear wheels. For example,
set the front wheels at 2-1/4 inches (6 cm) and
the rear wheels at 2-3/4 inches (7 cm).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than one pass over the leaves.
•
If there are more than 5 inches (13 cm) of leaves
on the lawn, set the front cutting height one or
two notches higher than the rear cutting height.
•
Slow down your mowing speed if the mower does
not cut the leaves finely enough.
Maintenance
Note:
Determine the left and right sides of the mower by standing in the operating position.
Recommended Maintenance Schedule
Important
: Refer to your engine operator’s manual for additional maintenance procedures.
Maintenance Service
Interval
Maintenance Procedure
Each Use
•
Check the engine oil level. Refer to Checking the Engine Oil Level on page 8.
•
Check the stopping time of the blade brake. The blade must stop within
3 seconds of releasing the blade control bar; if it does not, contact an Authorized
Service Dealer. Refer to Checking the Blade Brake Clutch Operation on
page 11.
•
Remove grass clippings and dirt from under the housing. Refer to Cleaning the
Mower on page 18.
1 Month (5 Hours)
1
•
Charge the Battery. Refer to Charging the Battery on page 17.
1 Year (25 Hours)
1
•
Replace the air filter; replace it more frequently in dusty operating conditions.
Refer to Replacing the Air Filter on page 16.
•
Check the spark plug (refer to your engine operator’s manual).
•
Replace the blade or have the blade sharpened; replace it or have it sharpened
more frequently if the edge dulls quickly. Refer to Replacing the Blade on
page 17.
•
Lubricate the wheel gears. Refer to Lubricating the Wheel Gears on page 17.
•
Clean the blade brake clutch (BBC) shield. Refer to Cleaning the Blade Brake
Clutch Shield on page 18.
2 Years (50 Hours)
1
•
Change the engine oil.
2
Refer to Changing the Engine Oil on page 17.
4 Years (100 Hours)
1
•
Replace the spark plug (refer to your engine operator’s manual).
•
Clean the cooling system (refer to your engine operator’s manual).
Annual Storage
•
Empty the fuel tank before repairs as directed or before annual storage. Refer to
Preparing the Mower for Storage on page 19.
•
Charge the Battery. Refer to Charging the Battery on page 17.
1
Whichever comes first
2
Change the engine oil after the first 5 operating hours.
Summary of Contents for 20058
Page 21: ...21 3352 864 Rev B ...
