Toro 20058, Operator'S Manual

9

3352-864 Rev B

Adjusting the Cutting Height

Warning

Adjusting the cutting height may bring you into contact with the moving blade, causing

serious injury.

S

Stop the engine and wait for all moving parts to stop.

S

Do not put your fingers under the housing when adjusting the cutting height.

Caution

If the engine has been running, the muffler will be hot and can severely burn you.
Keep away from the hot muffler.

Adjust the cutting height

as desired. Set all four

wheels to the same

height.

Note:

 To raise the mower,

move all 4 cutting height

levers forward; to lower

the mower, move them all

rearward.

m-5629a

m-8098

m-8100

E= 3-1/4 inch (8 cm)

F= 3-3/4 inch (10 cm)

G= 4-1/4 inch (11 cm)

A= 1-1/4 inch (3 cm)

B= 1-3/4 inch (4 cm)

C= 2-1/4 inch (6 cm)

D= 2-3/4 inch (7 cm)

Adjusting the Handle Height

You may raise or lower the handle to a position

comfortable for you.

1.

Remove the

lower handle knobs

and lock washers

that attach the

lower handle ends

to the handle

brackets.

m-8097

2.

Insert the bolt

through the hole in each

of the handle brackets

that sets the handle to

the desired position.

Note:

 A  is the

highest position; B

(either hole) is the

middle position; and

C is the lowest

position.

A

B

C

m-8101

3.

Install the lock

washers and lower

handle knobs and

tighten the knobs as

tight as you can.

Note:

 Ensure that

each lock washer is

between the handle

bracket and the

lower handle knob.

m-8097