5. Torque the handle bolts to 120 to 160 in-lb (14 to
17 N
⋅
m).
6. Adjust the cutting height. Refer to Adjusting the
Cutting Height.
3. Installing the Starter Rope
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 6).
Figure 6
1.
Starter rope
2.
Rope guide
Note:
To make the rope easier to install, squeeze the
control bar on the handle.
4. Filling the Engine with Oil
Procedure
Your mower does not come with oil in the engine.
1. Remove the dipstick (Figure 7).
Figure 7
2.
Slowly
pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 7).
Do
not overfill.
(Max. fill: 20 oz. (0.59 l), type: SAE
30W detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Important:
Change the engine oil after the first
5 operating hours
; change it yearly thereafter.
Refer to Changing the Engine Oil.
Product Overview
Figure 8
1.
Upper handle
7.
Cutting height lever (4)
2.
Control bar lock
8.
Oil fill/Dipstick
3.
Fuel tank cap
9.
Recoil start handle
4.
Side discharge
10.
Ignition switch
5.
Air filter
11.
Blade control bar
6.
Spark plug
Figure 9
1.
Grass bag
3.
Rear discharge plug
(installed)
2.
Side discharge chute
6
Summary of Contents for 20093
Page 20: ...Notes 20 ...
Page 21: ...Notes 21 ...
