Removing the Grass Bag
1. Route the starter rope around the lower rope guide
Figure 28
1.
Lower rope guide
Note:
The lower rope guide releases the starter rope
when you pull the recoil start handle.
2. Raise and hold up the discharge deflector.
3. Lift the grass bag up by the handle off the notches.
4. Install the rear discharge plug (Figure 29).
Figure 29
1.
Discharge deflector
2.
Rear discharge plug
Important:
Ensure that the rear discharge
plug is securely in place. Lift up the discharge
deflector and look for 2 tabs in front of the plug
(Figure 30). If you do not see them, firmly push
the plug in until it snaps into place.
Figure 30
1.
Tabs
5. Lower the discharge deflector.
Side-discharging the Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the mower, remove it and insert the rear
discharge plug (refer to Removing the Grass Bag) before
side-discharging the clippings.
Important:
Ensure that the rear discharge plug is
securely in place. Lift up the discharge deflector
and look for 2 tabs in front of the plug (Figure 31).
If you do not see them, firmly push the plug in until
it snaps into place (Figure 32).
Figure 31
1.
Tabs
12
Summary of Contents for 20093
Page 20: ...Notes 20 ...
Page 21: ...Notes 21 ...
