During Operation
During Operation Safety
General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including long pants;
eye and hearing protection; slip-resistant,
substantial foot protection; and hard hats. Tie back
long hair and do not wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Keep your hands and feet away from moving parts.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Do not operate near drop-offs, ditches, or
embankments.
•
Stop the machine whenever you are not operating
it.
•
Stop the machine and inspect the after striking
an object or if there is an abnormal vibration in
the machine. Make all necessary repairs before
resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Never run an engine in an area where exhaust
gasses are enclosed.
•
Never leave a running machine unattended.
•
Before leaving the operating position, do the
following:
– Move the machine to level ground.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Do not use the machine as a towing vehicle.
•
Use accessories, attachments, and replacement
parts approved by The Toro® Company only.
Slope Safety
When operating the machine on a slope, the operator
must account for many variables, such as the amount,
distribution, and height of the load; the stability of
the ground; uneven terrain and obstacles; and the
condition of the brakes. These and other variables
make it impractical to designate the maximum angle
at which the operator can safely use the machine for
all slopes and situations.
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. The operator is responsible for safe
slope operation. Operating the machine on any slope
requires extra caution. Before using the machine on a
slope, the operator must do the following:
•
Review and understand the slope instructions in
the manual and on the machine.
•
Evaluate the site conditions of the day to determine
if the slope is safe for machine operation. Use
common sense and good judgment when
performing this evaluation. Changes in the terrain,
such as moisture, can quickly affect the operation
of the machine on a slope.
•
Walk beside the machine when tramming up and
down slopes.
•
Identify hazards at the base of the slope. Do
not operate the machine near drop offs, ditches,
embankments, water or other hazards. The
machine could suddenly roll over if a track goes
over the edge or the edge collapses. Keep a safe
distance (twice the width of the machine) between
the machine and any hazard.
•
Avoid starting, stopping or turning the machine on
slopes. Avoid making sudden changes in speed or
direction; turn slowly and gradually.
•
Do not operate a machine under any conditions
where traction, steering or stability is in question.
Be aware that operating the machine on wet
terrain, across slopes or downhill may cause the
machine to slide even if the tracks are stopped.
•
Remove or mark obstacles such as ditches, holes,
ruts, bumps, rocks, or other hidden hazards.
Uneven terrain could overturn the machine.
54
Summary of Contents for 2226
Page 107: ...Notes ...
Page 108: ......
