Toro 22303, Operator'S Manual

20

7. Install the cylinder locks over the hydraulic hoses and

secure them with the clevis pins and cotter pins (Fig.
17).

m–4601

2

1

3

4

1

2

Figure 17

1.

Hydraulic hoses

2.

Cylinder locks

3.

Hairpin cotter

4.

Clevis pin

Installing and Removing
Attachments

Connecting an Attachment

Important

Use only Toro-approved  attachments.

Attachments can change the stability and the operating
characteristics of the traction unit.  The warranty of the
traction unit may be voided if used with unapproved
attachments.

Important

Before installing the attachment, ensure

that the mount plates are free of any dirt or debris and that
the pins rotate freely.  If the pins do not rotate freely,
grease them; refer to Greasing the Traction Unit, page 23.

1. Position the attachment on a level surface with enough

space behind it to accommodate the traction unit.

2. Start the engine.

3. Tilt the attachment mount plate forward.

4. Position mount plate into the upper lip of the

attachment receiver plate (Fig. 18).

m–4055

1

2

Figure 18

1.

Mount plate

2.

Receiver plate

5. Raise the loader arms while tilting back the mount

plate at the same time.

Important

The attachment should be raised enough

to clear the ground, and the mount plate should be
tilted all the way back.

6. Stop the engine.

7. Engage the quick attach pins, ensuring that they are

fully seated in the mount plate (Fig. 19).

Important

If the pins do not rotate to the engaged

position, the mount plate is not fully aligned with the
holes in the attachment receiver plate. Check the receiver
plate and clean it if necessary.

m–5919

1

3

2

Figure 19

1.

Quick attach pins (shown
in engaged position)

2.

Disengaged position

3.

Engaged position

If you do not fully seat the quick attach pins
through the attachment mount plate, the
attachment could fall off of the traction unit,
crushing you or bystanders.

Ensure that your quick attach pins are fully
seated in the attachment mount plate.

Warning

1. Position the attachment on a level surface with enough

space behind it to accommodate the traction unit.

2. Move the pump control lever to the turtle position.