34
PROBLEM
CORRECTIVE ACTION
POSSIBLE CAUSES
Excessive black smoke from
h
t
1. The air cleaner element is dirty.
1. Clean or replace.
exhaust.
2. The injection pump timing is
incorrect.
2. Contact your Authorized
Service Dealer.
3. Incorrect fuel is in the fuel
system.
3. Drain the fuel system and refill
with specified fuel.
4. The injection nozzles are
damaged.
4. Contact your Authorized
Service Dealer.
5. The injection pump is
damaged.
5. Contact your Authorized
Service Dealer.
6. Excessive loading.
6. Reduce load; use lower ground
speed.
Excessive white smoke from
exhaust.
1. The key was turned to the start
position before the glow plug
light turned off.
1. Turn the key to the run position
and allow the glow plug light to
turn off before starting the
engine.
2. The engine temperature is low.
2. Check the thermostat.
3. The glow plugs are inoperative.
3. Check the fuse, glow plugs and
wiring.
4. The fuel injection nozzles are
damaged.
4. Contact your Authorized
Service Dealer.
5. The injection pump timing is
incorrect.
5. Contact your Authorized
Service Dealer.
6. Low compression.
6. Contact your Authorized
Service Dealer.
Traction unit does not drive.
1. Traction pump drive coupler is
loose or broken.
1. Contact Authorized Service
Dealer.
2. Hydro fluid level low.
2. Add hydro fluid to reservoir.
3. Pump and/or wheel motor is
damaged.
3. Contact your Authorized
Service Dealer.
4. Control valve is damaged.
4. Contact your Authorized
Service Dealer.
5. Relief valve is damaged.
5. Contact your Authorized
Service Dealer.
6. The tow valves are open.
6. Close the tow valves.
7. Flow divider valve lever is in
9 o’clock position.
7. Move lever to 12 o’clock to
10 o’clock position.
Summary of Contents for 22303
Page 6: ...6 Slope Chart...
Page 35: ...35...