Stability Data
The following tables list the maximum slope recommended for the traction unit in the positions listed in the tables.
Slopes over the listed degree may cause the traction unit to become unstable. The data in the tables assume that the
loader arms are fully lowered; raised arms may affect the stability.
In each attachment manual is a set of three stability ratings, one for each hill position. To determine the maximum
slope you can traverse with the attachment installed, find the degree of slope that corresponds to the stability ratings
of the attachment. Example: If the attachment installed on a TX model 22323 traction unit has a Front Uphill rating
of B, a Rear Uphill rating of D, and a Side Uphill rating of C, then you could drive forward up a 19° slope, rearward
up a 12° slope, or sideways on a 14° slope, as listed in the following table.
Model 22323
Maximum Recommended Slope when
Operating with:
Front Uphill
Rear Uphill
Side Uphill
Configuration
Traction unit without attachment
11°
21°
19°
Traction unit with an attachment rated with one of the following stability ratings
for each slope position:*
A
25°
25°
20°
B
19°
19°
18°
C
16°
15°
14°
D
10°
12°
9°
E
5°
5°
5°
Model 22324
Maximum Recommended Slope when
Operating with:
Front Uphill
Rear Uphill
Side Uphill
Configuration
Traction unit without attachment
12°
19°
21°
Traction unit with an attachment rated with one of the following stability ratings
for each slope position:*
A
25°
25°
23°
B
22°
22°
20°
C
18°
16°
14°
D
10°
10°
10°
E
5°
5°
5°
16
Summary of Contents for 22319
Page 7: ...Slope Indicator 7...
Page 49: ...Schematics G007388 Electrical Schematic Rev B 49...
Page 50: ...Hydraulic Schematic Rev A 50...
Page 51: ...Notes 51...