Figure 48
1.
Road wheel
4.
Road wheel cap
2.
Gasket
5.
Snap ring
3.
Bolt
6.
Add grease under the cap
4. Check the grease under the cap and around the
gasket (Figure 48). If it is dirty, gritty, or depleted,
clean out all of the grease, replace the gasket, and
add new grease.
5. Ensure that the road wheel turns smoothly on the
bearing. If it is frozen, replace the road wheel as
described in the
Road Wheel Kit Installation Instructions
or contact your Authorized Service Dealer for repair.
6. Place the greased road wheel cap over the bolt head
7. Secure the road wheel cap with the snap ring
8. Repeat steps 3 through 7 for the other road wheels.
9. Install each track guide to the traction unit frame
using the fasteners you removed previously. Torque
the bolts to 67 to 83 ft-lb (91 to 112 N-m).
10. Install the tracks; refer to Replacing the Tracks.
Cooling System
Maintenance
Servicing the Cooling System
Service Interval:
Before each use or daily—Clean the
radiator.
Every 100 hours—Check the cooling
system hoses.
Yearly—Change the engine coolant
(Authorized Service Dealer only).
If the engine has been running, the pressurized,
hot coolant can escape and cause severe burns.
•
Do not remove the radiator cap when the
engine is hot. Always allow the engine to
cool at least 15 minutes or until the radiator
cap is cool enough to touch without burning
your hand before removing the radiator cap.
•
Do not touch radiator and surrounding parts
that are hot.
•
Use a rag when opening the radiator cap,
and open the cap slowly to allow steam to
escape.
Rotating shaft and fan can cause personal
injury.
•
Do not operate the machine without the
covers in place.
•
Keep fingers, hands and clothing clear of
rotating fan and drive shaft.
•
Shut off the engine and remove the ignition
key before performing maintenance.
Swallowing engine coolant can cause poisoning.
•
Do not swallow engine coolant.
•
Keep out of reach from children and pets.
39
Summary of Contents for 22319
Page 7: ...Slope Indicator 7...
Page 49: ...Schematics G007388 Electrical Schematic Rev B 49...
Page 50: ...Hydraulic Schematic Rev A 50...
Page 51: ...Notes 51...