Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Replace the hydraulic filter.
After the first 50 hours
• Change the engine oil and filter.
• Check and adjust the track tension.
Before each use or daily
• Check the engine oil level.
• Check the cooling system.
• Grease the traction unit. (Grease immediately after every washing.)
• Check the air filter service indicator.
• Drain water and other contaminants from the fuel filter/water separator.
• Clean the tracks.
• Check the tracks for excessive wear (If the tracks are worn, replace them.)
• Clean the radiator.
• Remove debris from the traction unit.
• Check for loose fasteners.
Every 25 hours
• Check the hydraulic fluid level.
• Remove air cleaner cover, clean out debris, and check the air filter service indicator.
Every 100 hours
• Change the engine oil.
• Check the battery electrolyte level (replacement battery only).
• Check the battery cable connections.
• Check and adjust the track tension.
• Check the cooling system hoses.
• Check the alternator/fan belt tension (refer to the Engine Operator’s Manual for
instructions).
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration.
• Check for dirt build-up in the chassis.
Every 200 hours
• Change the oil filter.
• Replace the hydraulic filter.
Every 250 hours
• Check and grease the road wheels.
Every 400 hours
• Check the fuel lines and connections for deterioration, damage, or loose connections.
• Replace the fuel filter canister and in-line filter.
• Change the hydraulic fluid.
Every 500 hours
• Replace the alternator/fan belt (refer to the Engine Operator’s Manual for
instructions).
Every 600 hours
• Replace the safety air filter.
Every 1,500 hours
• Replace all moving hydraulic hoses.
Yearly
• Change the engine coolant (Authorized Service Dealer only).
• Check the condition of the hydraulic pump belt.
Yearly or before storage
• Check and adjust the track tension.
• Touch up chipped paint
Every 2 years
• Drain and clean the fuel tank (Authorized Service Dealer only).
Important:
Refer to your
Engine Operator’s Manual
for additional maintenance procedures.
26
Summary of Contents for 22319
Page 7: ...Slope Indicator 7...
Page 49: ...Schematics G007388 Electrical Schematic Rev B 49...
Page 50: ...Hydraulic Schematic Rev A 50...
Page 51: ...Notes 51...
