Troubleshooting
Problem
Possible Cause
Corrective Action
1. The electrical connections are
corroded or loose.
1. Check the electrical connections for
good contact.
2. A fuse is blown or loose.
2. Correct or replace the fuse.
3. The battery is discharged.
3. Charge the battery or replace it.
4. The relay or switch is damaged.
4. Contact your Authorized Service
Dealer.
5. A starter or starter solenoid is
damaged.
5. Contact your Authorized Service
Dealer.
6. Internal engine components have
seized.
6. Contact your Authorized Service
Dealer.
The starter does not crank.
7. The safety interlock is engaged.
7. Check the neutral setting on the
traction and auxiliary controls.
1. The starting procedure is incorrect.
1. Refer to Starting the Engine.
2. The fuel tank is empty.
2. Fill the tank with fresh fuel.
3. The fuel-shutoff valve is closed.
3. Open the fuel-shutoff valve.
4. Dirt, water, stale fuel, or incorrect fuel
is in the fuel system.
4. Drain and flush the fuel system; add
fresh fuel.
5. The fuel line is clogged.
5. Clean or replace the fuel line.
6. There is air in the fuel.
6. Bleed the nozzles and check for air
leaks at the fuel hose connections
and fittings between the fuel tank and
engine.
7. The glow plugs are inoperative.
7. Check the fuse, glow plugs, and wiring.
8. The cranking speed is slow.
8. Check the battery, oil viscosity, and
starting motor (contact your Authorized
Service Dealer).
9. The air-cleaner filters are dirty.
9. Service the air filters.
10. The fuel filter is clogged.
10. Replace the fuel filter.
11. The improper fuel grade for cold
weather is in the machine.
11. Drain the fuel system and replace
the fuel filter. Add fresh fuel of
proper grade for ambient temperature
conditions. You may need to warm the
entire traction unit.
12. There is low compression.
12. Contact your Authorized Service
Dealer.
13. The injection nozzles are damaged.
13. Contact your Authorized Service
Dealer.
14. The injection pump timing is incorrect.
14. Contact your Authorized Service
Dealer.
15. The injection pump is damaged.
15. Contact your Authorized Service
Dealer.
The engine cranks but does not start.
16. The ETR solenoid is damaged.
16. Contact your Authorized Service
Dealer.
50
Summary of Contents for 22327
