14
Step
1
Removing the Shipping
Bracket
Parts needed for this step:
None
Procedure
1. Remove the center gage wheel nut, 2 large washers,
angle bracket and 1 small washer (Fig. 2). Discard the
2 large washers and the angle bracket.
1
2
m–7585
3
3
4
5
Figure 2
1.
Center Gage Wheels and
Spacer
2.
Nut
3.
Large washer—discard
4.
Angle bracket—discard
5.
Small washer
2. Install the center gage wheels with the previously
removed bolt, small washer and nut (Fig. 3).
1
2
3
4
4
m–7678
5
Figure 3
1.
Center Gage Wheels and
Spacer
2.
Nut
3.
Bolt
4.
Washer
5.
Spacer
Step
2
Installing the Handle Assembly
Parts needed for this step:
Qty.
Part
1
Handle assembly
4
Bolt, 5/16 X 7/8 inch
4
Lock nut, 5/16 inch
1. Align handle with upper mounting holes in rear frame
(Fig. 4).
2. Secure the handle at each upper mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 4).
3. Select the low position for the lower mounting hole
(Fig. 4).
4. Secure the handle at each lower mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 4).
Note: The handle position can be adjusted to match the
operator’s height preference.
