18
3
4
2
1
5
6
m–6582
Figure 12
1.
Handle
2.
Neutral/Parking brake
lock
3.
3/16 inch to 1/4 inch
(5 mm to 6 mm)
clearance
4.
Drive lever
5.
Drive position
6.
Control Rod
Step
6
Installing the Hairpin Cotter
Pins and Spacers
Parts needed for this step:
Qty.
Part
2
Hairpin cotter pin
6
Spacers
Procedure
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
Note: Make sure there is at least one spacer used on each
height–of–cut post.
1. Remove the existing rear hairpin cotter pins from the
rear height–of–cut posts.
2. Install a spacer onto both rear height–of–cut posts and
install the hairpin cotter pins.
3
2
1
m–7584
Figure 13
1.
Hairpin cotter
2.
Spacer
3.
Height–of–cut post (rear
shown)
3. On the opposite side of the muffler, install unused
spacers onto front and rear height–of–cut pins and insert
the hairpin cotter pins (Fig. 14).
m-6505
3
2
1
Figure 14
1.
Hairpin cotter
2.
Unused spacers
3.
Height–of–cut post (front
shown)
