3
SET-UP INSTRUCTIONS
ACTUATOR
1.
Pivot Broom head until the actuator can be
attached to the Broom head frame.
2.
Secure motor end (motor facing right) of
actuator to Broom head frame with the cap
screw and locknut. Attach the shaft end of the
actuator to the tank / frame mount with the cap
screw, bushing and locknut.
GENERAL
Refer to illustrated parts list for details of parts used in assembling and installing the ELECTRIC SWIVEL
OPTION.
NOTE:
"Right", "Left", "Front" and "Rear" are referenced while sitting in the Vehicle operator's seat.
Quick Pins
DEBRIS HAS CONSIDERABLE FORCE
AND COULD CAUSE INJURY.
Stay away from sweeping area when
machine is operating.
Keep bystanders away from sweeping
area when machine is running.
WARNING
OPERATION
Toggle control box Broom Angle switch left or right
until desired position is reached and release switch.
BROOM CONTROL BOX AND
WIRING
1.
Attach Broom control box to the steering
column with clamp, gaskets, washers and nuts
about 6 inches below steering wheel.
2.
Route the actuator wire through the steering
column and connect to actuator.
3.
Remove the Tractor instrument panel cover.
4.
Route the power wires through the steering
column and frame to the instrument panel and
attach the negative wire (black) to the common
ground terminal and the positive wire (red) to
the rear terminal of the fuel gauge. Reinstall
cover.
OPERATING INSTRUCTIONS
MAINTENANCE
IMPORTANT:
Shear bolt at shaft end of actuator
must only be replaced with a 1/4" UNC x 2 " Allthread
Grade 2 bolt (100-5858).