Figure 13
1.
The oil level is at its
maximum.
3.
The oil level is too
low—add oil to the
crankcase.
2.
The oil level is too
high—remove oil from
the crankcase.
9.
If the oil level is low,
slowly
pour oil into the oil-fill
hole. Wait 3 minutes, then check the oil level on the
dipstick by wiping the dipstick clean and then inserting,
but not screwing in,
the oil-fill cap into the hole.
Note:
You may tip the machine forward (handle up)
a little to make adding oil easier. Remember to return
the machine to the operating position before checking
the oil level.
Important:
Do not tip the machine all the way
forward onto its nose, or fuel may leak out of the
machine.
Max fill: 0.35 L (12 oz), type: automotive detergent oil
with an API service classification of SJ, SL, or higher.
Use
to select the best oil viscosity for the
outdoor temperature range expected:
Figure 14
Note:
Fill the engine crankcase with oil until the
dipstick indicates that the engine oil level is correct as
shown in
. If you overfill the engine with oil,
remove the excess oil as directed in
(page )
.
10.
Screw the oil-fill cap into the oil-fill hole and hand
tighten it securely.
During Operation
Safety
•
Rotating rotor blades can injure fingers or hands.
Stay behind the handles and away from the discharge
opening while operating the machine.
Keep your face,
hands, feet, and any other part of your body or
clothing away from moving or rotating parts.
•
Never direct the discharge toward people or areas where
property damage can occur.
•
Exercise caution to avoid slipping or falling. Always be
sure of your footing, and keep a firm hold on the handles.
Walk; never run.
•
Exercise extreme caution when operating on slopes.
•
Never operate the machine without good visibility or
light.
•
Look behind and use care when backing up with the
machine.
•
When not actively clearing snow, disengage power to the
rotor blades.
•
Use extension cords and receptacles as specified by
the manufacturer for all machines with electric starting
motors.
•
Do not attempt to clear snow from a gravel or crushed
rock surface. This product is intended for use only on
paved surfaces.
•
Do not use the machine on a roof.
9
