2. Installing the Discharge
Chute
3
Screws
1
Chute assembly
Procedure
Install the discharge chute as shown (Figure 6).
Figure 6
1.
Discharge chute
2.
Screw (3)
Note:
For easier installation, use a small ratchet wrench
to tighten the screws.
Important:
Do not overtighten the screws;
otherwise you may damage the discharge chute and
prevent it from turning freely.
3. Filling the Engine with Oil
Procedure
Your snowthrower does not come with oil in the engine,
but it does come with a bottle of oil.
Important:
Before starting the engine, fill the
engine with oil.
Note:
The bottle of oil may contain more than is
required. Do not overfill the engine.
Max fill: 21 oz. (0.62 l), type: automotive detergent oil
with an API service classification of SJ, SL, or higher.
•
For temperatures above 32°F (0°C), use SAE 30.
•
For temperatures between 0°F and 32°F (–18°C and
0°C), use SAE 5W30 or SAE 10.
•
For temperatures below 0°F (–18°C), use SAE
0W30.
1. Move the snowthrower to a level surface.
2. Clean around the oil fill cap (Figure 7).
Figure 7
1.
Oil fill cap
3. Unscrew the oil fill cap and remove it.
4. With the snowthrower in the operating position,
carefully
pour oil into the crankcase until the point
of overflow.
5. Screw the oil fill cap into the oil fill hole and tighten
it securely.
4. Adjusting the Control Cable
Procedure
Refer to Adjusting the Control Cable in Maintenance.
6
