12. Align the tab on the choke control knob with the
slot on the upper snow hood.
13. Connect the choke control knob to the choke shaft
on the carburetor.
Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover (Figure 54),
lift the front of the cover up, and slide it back and
out of the way.
Figure 54
2. Loosen the bolt on the cable clamp (Figure 55).
Figure 55
1.
Cable conduit
2.
Cable clamp
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 55 and Figure 56).
Figure 56
1.
Discharge chute latch
2.
Gear teeth
Note:
The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 56).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go
to www.Toro.com for additional service information or
have an Authorized Service Dealer replace the belt.
Replacing the Headlight Bulb
Use a
GE 892 16W halogen light bulb.
Do not touch
the bulb with your hands or allow dirt or moisture to
come into contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 57).
Figure 57
2. Turn the base of the bulb counterclockwise until it
stops (Figure 58).
25
Summary of Contents for 38637C
Page 30: ...Notes 30 ...
Page 31: ...Notes 31 ...
