Shroud Replacement
Shroud Removal
1. Park the machine on a level surface. Stop the engine, wait for all moving
parts to stop and remove the key.
2. Remove the 3 (1/4-10 x 2 inch) plastite screws securing the chute to chute
seal ring. Remove the chute from the chute ring.
Note:
QZE models have a 1/4–10 x 1.5 inch plastite screw.
Note:
Some models will have a chute handle attached to the chute.
g321389
Figure 42
3. Remove the (M4.2–2.25 mm x 3/4 inch) screw securing the chute seal ring to
the shroud. Remove the chute seal ring from the shroud.
g320929
Figure 43
4. Remove the 2 (1/4-10 x 13/16 inch) screws securing the LH shroud retainer
to the LH shroud. Repeat the procedure on the RH side of the machine.
Chassis: Service and Repairs
Page 5–8
POWER CLEAR® 721/821 Snowthrower Service Manual
3438-776 Rev A
