Lubrication
Greasing the Sprayer
Service Interval:
Every 50 hours—Lubricate the pump.
Every 50 hours/Yearly (whichever comes first)
Grease Type:
No. 2 general-purpose, lithium-based grease.
Toro Premium All Purpose Grease is available from your
Toro Distributor.
1.
Wipe the grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2.
Pump grease into the bearing or bushing.
3.
Wipe off excess grease.
The grease fittings positions are illustrated in
and
1
g018935
Figure 51
Pump center
1.
Grease point
Figure 52
Three fittings inside each front wheel
1.
Grease point
Greasing the Boom Hinges
Service Interval:
Every 100 hours
Important:
If the boom hinge is washed with water,
all water and debris must be cleared from the hinge
assembly and fresh grease must be applied.
Grease Type:
No. 2 general-purpose, lithium-based grease.
1.
Wipe the grease fittings clean so that foreign matter
cannot be forced into the bearing or bushing.
2.
Pump grease into the bearing or bushing at each fitting
Figure 53
Right boom
1.
Grease fitting
3.
Wipe off excess grease.
4.
Repeat the procedure for each boom pivot.
Greasing the Actuator Rod
Bearings
Service Interval:
Every 400 hours/Yearly (whichever comes
first)
Grease Type:
No. 2 general-purpose, lithium-based grease.
1.
Extend the booms to the spray position.
2.
Remove the cotter pin from the pivot pin (
).
3.
Lift up on the boom and remove the pin (
).
Slowly lower the boom to the ground.
4.
Inspect the pin for any damage, replace if necessary.
42
