Operation
Starting the Hedge Trimmer
1.
Remove the protective cover from the cutter
blades (
WARNING
The hedge trimmer blades can cause
cuts or amputation.
Be careful when handling the hedge
trimmer with the protective cover
removed.
g203890
Figure 3
1.
Protective cover
2.
Blades
2.
Make sure that the vents on the hedge trimmer
are clear of any dust and debris.
3.
Align the cavity of the battery pack with the
tongue in the handle housing, grasp the handle,
and push the battery pack into the handle until
the latch locks into place (
).
g228569
Figure 4
1.
Auxiliary-handle switch
4.
Trigger
2.
Auxiliary handle
5.
Battery latch
3.
Lock switch
6.
Hedge trimmer venting
areas
4.
Place 1 hand on the trigger handle. Place the
other hand on the auxiliary handle (
5.
Press the lock switch and then squeeze
the trigger switch while engaging the
auxiliary-handle switch to turn on the hedge
trimmer (
The trimmer stays on as long as the
auxiliary-handle switch is engaged and the
trigger is squeezed. You may release the
lock switch once the hedge trimmer is running
(
).
Rotating the Hedge Trimmer
Handle
1.
Press and hold the rotational lock button (A of
2.
Rotate the handle 90° to the right or left
depending on desired cutting direction, then
release the rotational lock button to lock the
handle in the desired position (B of
g190070
Figure 5
Shutting Off the Hedge
Trimmer
To shut off the hedge trimmer, release the trigger or
auxiliary-handle switch, or both (
). Allow at
least 5 seconds for the cutting blade to stop moving.
Whenever you are not using the trimmer or are
transporting the trimmer to or from the work area,
remove the battery pack.
9
Summary of Contents for 51136
