background image

21

Warranty

Warranty

The following California Air Resources Board (CARB) statement only applies to model numbers required to 
meet the CARB requirements.

The U.S. Environmental Protection Agency (EPA), the California Air Resources 
Board (CARB), and Techtronic Industries North America, Inc., are pleased to 
explain the Emissions Control System Warranty on your non-road or small 
off-road engine. In California, new equipment that uses small off-road engines 
must be designed, built, and equipped to meet the state’s stringent anti-smog 
standards. In other states, new 2011 and later model year non-road engines 
must be designed, built, and equipped at the time of sale to meet the U.S. EPA 
regulations for small non-road engines. The non-road engine must be free from 
defects in materials and workmanship which cause it to fail to conform with 
U.S. EPA standards for the first three years of engine use from the date of sale 
to the ultimate purchaser. Techtronic Industries North America, Inc., must war-
rant the emission control system on your non-road or small off-road engine for 
the period of time listed above provided there has been no abuse, neglect, or 
improper maintenance of your non-road or small off-road engine.
Your emission control system may include parts such as the carburetor or fuel 
injection system, the ignition system, catalytic converters, fuel tanks, valves, 
filters, clamps, connectors, and other associated components. Also included 
may be hoses, belts and connectors, and other emission-related assemblies.
Where a warrantable condition exists, Techtronic Industries North America, Inc., 
will repair your non-road or small off-road engine at no cost to you, including 
diagnosis, parts, and labor performed at an authorized service center for Toro

®

 

brand outdoor products.

MANUFACTURER’S WARRANTY COVERAGE:

This product’s emissions control system is warranted for three years. If any 
 emission-related part on your engine is defective, the part will be repaired or 
replaced by Techtronic Industries North America, Inc., free of charge.

OWNER’S WARRANTY RESPONSIBILITIES

(a) As the non-road or small off-road engine owner, you are responsible for 
the performance of the required maintenance listed in your operator’s manual. 
Techtronic Industries North America, Inc., recommends that you retain all 
receipts covering maintenance on your non-road or small off-road engine, but 
Techtronic Industries North America, Inc., cannot deny warranty solely for the 
lack of receipts or for your failure to ensure the performance of all scheduled 
maintenance. Any replacement part or service that is equivalent in performance 
and durability may be used in non-warranty maintenance or repairs, and shall 
not reduce the warranty obligations of Techtronic Industries North America, 
Inc., (b) As the non-road or small off-road engine owner, you should be aware, 
however, that Techtronic Industries North America, Inc., may deny you war-
ranty coverage if your non-road or small off-road engine or a part has failed 
due to abuse, neglect, improper maintenance, or unapproved modifications.
(c) You are responsible for presenting your non-road or small off-road engine to 
an authorized service dealer as soon as a problem exists. The warranty repairs 
should be completed in a reasonable amount of time, not to exceed 30 days.
If you have any questions regarding your warranty rights and responsibilities, 
you should contact a Techtronic Industries North America, Inc., Customer Rep-
resentative at 1-866-574-9242 (US) or 1-866-574-9243 (Canada).

DEFECT WARRANTY COVERAGE REQUIREMENTS:

(a) The warranty period begins on the date the engine or equipment is delivered 
to an ultimate purchaser. 
(b) General Emissions Warranty Coverage. Techtronic Industries North America, 
Inc., warrants to the ultimate purchaser and each subsequent purchaser that 
your non-road or small off-road engine is designed, built, and equipped at the 
time of sale to conform with all applicable regulations adopted by the California 
Air Resources Board or the United States Environmental Protection Agency; 
and that it is free from defects in materials and workmanship which cause the 
engine to fail to conform with applicable regulations for a period of three years 
from the date the non-road or small off-road engine is purchased by the initial 
purchaser. 
(c) The warranty on emissions-related parts will be interpreted as follows: Any 
warranted part that is not scheduled for replacement as required in the Emissions 
Maintenance Schedule and Warranty Parts List set forth below is warranted for 
three years. If any such part (including any part that is scheduled only for regular 
inspection) fails during the period of warranty coverage, it will be repaired or 
replaced at any Authorized Service Center at no charge. Any such part repaired 
or replaced under warranty will be warranted for the remaining warranty period. 
A statement to the effect of “repair or replace as necessary” would not reduce 
the period of warranty coverage. Any warranted part that is scheduled for re-
placement as required maintenance in the Emissions Maintenance Schedule and 
Warranty Parts List is warranted for the period of time prior to the first scheduled 

replacement point for that part. Any such part repaired or replaced under war-
ranty is warranted for the remainder of the period prior to the first scheduled 
replacement point, and will be repaired or replaced at any Authorized Service 
Center for no charge until that replacement point is reached. 
Techtronic Industries North America, Inc., shall remedy warranty defects at any 
authorized Authorized Service Center, including any distribution center that 
may be franchised to service the subject engines. Any diagnostic work done at 
a Authorized Service Center shall be free of charge to the owner if such work 
determines that a warranted part is defective. Any manufacturer-approved or 
equivalent replacement part may be used for any warranty maintenance or 
repairs on emission-related parts, and must be provided free of charge to the 
owner if the part is still under warranty. Techtronic Industries North America, 
Inc., is liable for damages to other engine components caused by the failure of 
a warranted part still under warranty.
Add-on or modified parts that are not exempted by the California Air Resource 
Board may not be used. The use of any non-exempted add-on or modified parts 
will be grounds for disallowing a warranty claim. Techtronic Industries North 
America, Inc., will not be liable to warrant failures of warranted parts caused by 
the use of a non-exempted add-on or modified part. 
The California Air Resources Board’s Emission Warranty Parts List specifically 
defines the emission-related warranted parts. (EPA’s regulations do not include 
a parts list, but the EPA considers emission-related warranted parts to include 
all the parts listed below.) Techtronic Industries North America, Inc., will provide 
any documents that describe its warranty procedures or policies within five days 
upon request by the California Air Resources Board.

EMISSIONS PARTS LIST

Emissions parts vary from product to product. Your emissions control system 
warranty applies to any of the following components that may be included on 
your product:
(1)  Fuel Metering System 
 

(i)  Carburetor and internal parts (and/or pressure regulator or fuel injection 

system). 

 

(ii)  Air/fuel ratio feedback and control system.

 

(iii)  Cold start enrichment system.

 

(iv)  Fuel Tank.

(2)  Air Induction System
 

(i)  Controlled hot air intake system.

 

(ii)  Intake manifold.

 

(iii)  Air filter.

(3)  Ignition System
 

(i)  Spark Plugs.

 

(ii)  Magneto or electronic ignition system.

 

(iii)  Spark advance/retard system.

(4)  Exhaust Gas Recirculation (EGR) System
 

(i)  EGR valve body and carburetor spacer, if applicable. 

 

(ii)  EGR rate feedback and control system.

(5)  Air Injection System
 

(i)  Air pump or pulse valve.

 

(ii)  Valves affecting distribution of flow.

 

(iii)  Distribution manifold.

(6)  Catalyst or Thermal Reactor System
 

(i)  Catalytic converter.

 

(ii)  Thermal reactor.

 

(iii)  Exhaust manifold.

(7)  Particulate Controls
 

(i)  Traps, filters, precipitators, and any other device used to capture par-

ticulate emissions.

(8)  Miscellaneous Items Used in Above Systems
 

(i)  Electronic controls.

 

(ii)  Vacuum, temperature, and time sensitive valves and switches. 

 

(iii)  Hoses, belts, connectors, and assemblies.

Techtronic Industries North America, Inc., will furnish with each new engine 
written instructions for its maintenance and use by the owner.

TECHTRONIC INDUSTRIES NORTH AMERICA, INC., LIMITED WARRANTY STATEMENT FOR FEDERAL AND 

CALIFORNIA EMISSION CONTROL SYSTEMS NON-ROAD AND SMALL OFF-ROAD ENGINES
YOUR WARRANTY RIGHTS AND OBLIGATIONS

Summary of Contents for 51945
























Reviews: