2
2
3
G005077
1
2
2
3
Figure 65
1.
Mower deck
3.
Rear lift rod
2.
Hanger bracket
6.
Slide the mower deck rearward to remove the mower
belt from the engine pulley.
7.
Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Mower Belt Maintenance
Inspecting the Belts
Service Interval:
Every 25 hours—Check the belts for
wear/cracks.
Check the belts for cracks, frayed edges, burn marks, or any
other damage. Replace damaged belts.
Replacing the Mower Belt
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks, and cracks are
signs of a worn mower belt. Replace the mower belt if any of
these conditions are evident.
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Set the height-of-cut at the lowest cutting position [38
mm (1-1/2 inch)].
4.
Using a spring removal tool, (Toro part no. 92-5771),
remove the idler spring from the deck hook to remove
tension on the idler pulley and roll the belt off of the
pulleys (Figure 66).
WARNING
The spring is under tension when installed
and can cause personal injury.
Be careful when removing the belt.
g017643
4
6
3 2 5
1 3
7
7
Figure 66
1.
Idler pulley
5.
Engine pulley
2.
Mower belt
6.
Spring removal too
3.
Outside pulley
7.
Mower deck handles
4.
Spring
5.
Route the new belt around the engine pulley and
mower pulleys (Figure 66).
6.
Using a spring removal tool, (Toro part no. 92-5771),
install the idler spring over the deck hook and placing
tension on the idler pulley and mower belt (Figure 66).
Installing the Mower
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Slide the mower under the machine.
4.
Lower the height-of-cut lever to the lowest position.
5.
Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod (Figure 65).
6.
Attach the front support rod to the mower deck with
the clevis pin and hairpin cotter (Figure 64).
43
Summary of Contents for 74395
Page 10: ...119 8874 1 Low speed 2 High speed 10 ...
Page 50: ...Schematics g017655 Electrical Diagram Rev A 50 ...
Page 51: ...Notes 51 ...
