Figure 52
1.
Cutting edge
3.
Wear/slot forming
2.
Curved area
4.
Damage
Checking for Bent Blades
Note:
The machine must be on a level surface for the
following procedure.
1.
Raise the mower deck to the highest height-of-cut
position; also considered the 'transport' position.
2.
While wearing thickly padded gloves or other adequate
hand protection slowly rotate blade to be measured
into a position that allows effective measurement of
the distance between the cutting edge and the level
surface the machine is on.
G014972
1
2
3
Figure 53
1.
Deck
3.
Blade
2.
Spindle housing
3.
Measure from the tip of the blade to the flat surface
here.
G014973
1
2
3
Figure 54
1.
Blade, in position for measuring
2.
Level surface
3.
Measured distance between blade and surface (A)
4.
Rotate the same blade 180 degrees so that the opposing
cutting edge is now in the same position.
G014974
1
2
3
Figure 55
1.
Blade, side previously measured
2.
Measurement position used previously
3.
Opposing side of blade being moved into measurement
position
5.
Measure from the tip of the blade to the flat surface
here. The variance should be no more than 3mm (1/8
inch).
39
Summary of Contents for 74395
Page 10: ...119 8874 1 Low speed 2 High speed 10 ...
Page 50: ...Schematics g017655 Electrical Diagram Rev A 50 ...
Page 51: ...Notes 51 ...
