Figure 87
1.
Deck-lift pedal
3.
Transport lock
2.
Height-of-cut pin
6.
Insert the height-adjustment pin into the 7.6 cm (3
inch) cutting-height position.
7.
Release the transport lock and allow the deck to lower
to the cutting height.
8.
Raise the discharge chute.
9.
On both sides of the deck, measure from the level
surface to the front tip of the blade (Position A); refer
to
.
Note:
The measurement should read 7.6 mm (3
inches).
Figure 88
1.
7.6 cm (3 inches) at
position A is correct
3.
Measure here, from the
blade tip, to the hard
surface
2.
8.3 cm (3–1/4 inches) at
position B is correct
4.
Measure at position A and
B on both sides
10.
If needed, loosen the flanged locknut on the side of the
yoke and the jam nut on top. Fine-tune the adjuster
screw by turning it to get 7.6 mm (3 inch) height
(
).
Note:
To increase the height, turn the adjuster
screw clockwise; to decrease the height, turn it
counterclockwise.
Figure 89
1.
Flanged locknut
3.
Jam nut
2.
Adjuster screw
4.
Yoke
11.
If the front deck links do not have enough adjustment
to achieve the accurate cut height, you can use the
single point adjustment can be utilized to gain more
adjustment.
12.
To adjust the single point system, loosen the 2 bolts at
the bottom of the height-of-cut plate. Refer to
56
