10.
If needed, loosen the whizlock nut on the side of the
yoke and the jam nut on top. Fine tune the screw
adjuster by turning it to get 7.6 mm (3 inch) height (see
To increase the height, turn the adjuster screw
clockwise; to decrease, turn counterclockwise.
Figure 87
1.
Whizlock nut
3.
Jam nut
2.
Adjuster screw
4.
Yoke
11.
If the front deck links do not have enough adjustment
to achieve accurate cut height , the single point
adjustment can be utilized to gain more adjustment.
12.
To adjust the single point system, loosen the two bolts
at the bottom of the height of cut plate. Refer to
Figure 88
1.
Bolts at the bottom of the height-of-cut plate
13.
If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If the deck is
too high, loosen the single point adjustment bolt by
rotating it counterclockwise (
Note:
Loosen or tighten the single point adjustment
bolt enough to move the height-of-cut plate mounting
bolts at least 1/3 the length of the available travel
in their slots. This will regain some up and down
adjustment on each of the four deck links.
g017036
Figure 89
1.
Single point adjustment bolt
14.
Tighten the two bolts at the bottom of the height of cut
plate (
). Torque to 37-45 N-m (27-33 ft-lb).
Note:
In most conditions, the back blade tip should
be adjusted 6.4 mm (1/4 inch) higher than the front.
15.
On both sides of the deck, measure from the level
surface to the back tip of the blade (Postion B). The
measurement should read 8.3 cm (3 1/4 inches) (
16.
Fine tune the screw adjuster by turning it to get 8.3 mm
(3–1/4 inches) height (
).
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
17.
Measure until all four sides are the correct height.
Tighten all the nuts on the deck-lift arm assemblies.
18.
Lower discharge chute.
Servicing the Cutting Blades
Maintain sharp blades throughout the cutting season because
sharp blades cut cleanly without tearing or shredding the grass
blades. Tearing and shredding turns grass brown at the edges,
which slows growth and increases the chance of disease.
Check the cutter blades daily for sharpness, and for any
wear or damage. File down any nicks and sharpen the
blades as necessary. If a blade is damaged or worn, replace
it immediately with a genuine Toro replacement blade. For
convenient sharpening and replacement, you may want to
keep extra blades on hand.
57
Summary of Contents for 74955
Page 65: ...Schematics G020788 Electrical Schematic Rev A 65 ...
Page 66: ...Notes 66 ...
Page 67: ...Notes 67 ...
