Operation
7
Attachment Lift
The attachment lift (Fig. 7) is used to raise and lower
attachments.
Raising Attachments
1.
Place your foot on the lift pedal (Fig. 7).
2.
Push down with your foot, release the lock by
rocking the pedal with your heel, then press with
your toe to raise the attachment lift (Fig. 7).
Remove your foot to hold the attachment in the
up, or raised position.
Lowering Attachments
1.
Place your foot on the lift pedal (Fig. 7).
2.
Push down with your foot, release the lock by
rocking the pedal with your heel, then release
foot pressure to lower the attachment lift
(Fig. 7). Remove your foot to hold the
attachment in the down, or desired position.
m–2716
2
1
Figure 7
1.
Lift pedal -UP
2.
Lift pedal-DOWN
Adjusting the Height-of-Cut
The pins and stabilizer bars are used to adjust the
height-of-cut range; refer to; Setting the Front-to-Rear
Pitch page 14.
1.
Set the stabilizer bars for the desired cut height
range, refer to; Setting the Front–to–Rear Pitch
page 14.
2.
Loosen down stop on attachment lift (Fig. 8).
3.
Set attachment lift to the correct position for
selected cut height (Fig. 8).
4.
Slide down stop against attachment lift and
tighten bolt (Fig. 8).
1
2
Figure 8
1.
Attachment lift
2.
Down stop
