3.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4.
Open the hood to access the fluid reservoir.
5.
Clean around the fill cap and remove the cap.
6.
Extract the fluid through the fill port using a
vacuum device or remove the power unit from
the deck and pour the fluid out.
7.
Install the power unit if you removed it to drain.
8.
Add approximately 710 ml (24 fl oz) Toro
Premium Transmission/Hydraulic Tractor Fluid
and install the cap.
Important:
Do not overfill the power unit;
overfilling the power unit may damage it.
9.
Ensure that the fluid level is correct; refer to
Checking the Deck-Lift Power Unit Fluid Level
(page 57)
.
Mower Deck
Maintenance
Leveling the Mower Deck
Setting up the Machine
Note:
Ensure that the mower deck is level before
matching the height of cut (HOC).
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Check tire pressure of the drive tires.
If needed, adjust to 124 kPa (18 psi).
4.
Position the mower to the 102 mm (4 inches)
height-of-cut position.
Leveling the Center Deck and
Wing Decks
1.
Raise the center deck and fold the wings by
pressing down at the rear of the deck-lift switch.
Hold the switch down until both wings are
completely folded.
2.
Position the mower to the 102 mm (4 inches)
height-of-cut position.
3.
Unlock the left and right wing deck cam locks
(
).
4.
Remove and retain the wing deck height-of-cut
lanyard (
).
58
Summary of Contents for Air Cool Z Master 74090
Page 69: ...g008623 Hydraulic Schematic Rev A 69 ...
Page 72: ......
