Cleaning
Cleaning the Machine and
Mower Deck
Service Interval:
Before each use or daily
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean off any oil, debris, or grass build-up on
the machine and mower deck, especially under
the deck-belt shields, around the fuel tank, and
around the engine and exhaust area.
4.
Raise the center deck and wing decks. Lock
each wing deck in the upright position.
5.
Clean out any grass build-up from the underside
of deck and in the discharge deflector.
Cleaning the Hydro Fan
Cooling Guards, Hydro
Cooling Fins, and Fan
Service Interval:
Before each use or daily
Remove the debris from the hydro fan cooling guards,
hydro cooling fins, and fan to allow the hydro system
to run cooler and improve the life of the hydro system.
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Slide the seat all the way back, lift the seat to
access the left and right hydro drives area.
4.
Remove any debris from the hydro fan cooling
guards, hydro cooling fins, and fan.
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
64
Summary of Contents for Air Cool Z Master 74090
Page 69: ...g008623 Hydraulic Schematic Rev A 69 ...
Page 72: ......
