g020928
Figure 5
1.
Locking collar
2.
Set screw
6.
Position the large spring over the cable (
g020929
Figure 6
1.
Large spring
7.
Set the cable into the left brake-bar bracket, and
secure it with a locking collar and a setscrew
assembly (
).
Note:
The cable must be securely held in the
bracket with no movement.
g020930
Figure 7
1.
Locking collar
2.
Setscrew assembly
4
Installing the Parking-Brake
Locking Mechanism
Parts needed for this procedure:
1
Convoluted cable tube
4
Bolt (5/16 x 1 inch)
4
Locknut (5/16 inch)
Procedure
1.
Slide the convoluted cable tube over the brake
cable (
).
g020931
Figure 8
1.
Parking brake cable with the convoluted tube
2.
From under the machine, route the end of the
cable through the frame in the lower-left corner
of the frame (
Note:
Ensure that convoluted cable tube
protrudes at least 10 to 15 cm (4 to 6 inches)
through the hole.
3.
Position the brake assembly under the machine
against the back of the frame with the brake
bars through the holes in the side of the frame,
located in front of the wheel motors (
4
Summary of Contents for Dingo 22366
Page 11: ...Notes...
Page 12: ......
