Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
Note:
Using a height-of-cut under 51 mm (2 inches)
increases the wear on the mower-deck belt. Use a
height-of-cut that is greater than 51 mm (2 inches)
whenever possible.
g267253
Figure 22
Adjusting the Flow Baffle
You can adjust the mower-discharge flow for different
types of mowing conditions. Position the cam lock
and baffle to provide the best quality of cut.
1.
Disengage the PTO, move the motion-control
levers to the N
EUTRAL
-
LOCK
position, and
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
To adjust the baffle, loosen the knob (
).
4.
Adjust the baffle and knob in the slot to the
desired discharge flow and tighten the knob.
g301806
Figure 23
1.
Slot
2.
Knob
20
Summary of Contents for GrandStand 72504TE
Page 58: ...Schematics g302050 Electrical Schematic 140 1878 Rev A 58 ...
Page 59: ...Notes ...