g031282
Figure 7
1.
The triangles light up when the interlock components are
in the correct position.
Testing the Safety-Interlock
System
Service Interval:
Before each use or daily
Test the safety-interlock system before you use the
machine each time.
Note:
If the safety system does not operate as
described below, have an Authorized Service Dealer
repair the safety system immediately.
1.
Start the engine; refer to
(page 16)
.
2.
Move the motion-control levers to the center,
unlocked position.
Note:
The blades/attachment should stop and
the engine should stop running.
3.
Start the engine and disengage the parking
brake.
4.
Move either motion-control lever to the center,
unlocked position.
5.
Continue holding the motion-control lever in
the center, unlocked position and press the O
N
position on the PTO switch.
Note:
The clutch and blades/attachment should
engage.
6.
Move or release the motion-control levers into
the N
EUTRAL
-
LOCK
position.
Note:
The blades/attachment should stop and
the engine should continue to run.
7.
Press the O
FF
position on the PTO switch and
move either motion-control lever to the center,
unlocked position.
8.
Continue holding the motion-control lever in
the center, unlocked position and press the O
N
position on the PTO switch.
Note:
The clutch and blades/attachment should
engage.
9.
Press the O
FF
position on the PTO switch.
Note:
The blades/attachment should stop.
10.
With the engine running, press the O
N
position
on the PTO switch without holding either
motion-control lever to the center, unlocked
position.
Note:
The blades/attachment should not
engage.
During Operation
During Operation Safety
General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
•
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Avoid mowing in
wet conditions.
•
Before you start the engine, ensure that all drives
are in neutral, the parking brake is engaged, and
you are in the operating position.
•
Ensure that you have good footing while using this
machine, especially when backing up.
•
Keep your hands and feet away from the cutting
units. Keep clear of the discharge opening at all
times.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use extreme care when approaching blind
corners, shrubs, trees, or other objects that may
block your view.
12
Summary of Contents for GrandStand 72504TE
Page 58: ...Schematics g302050 Electrical Schematic 140 1878 Rev A 58 ...
Page 59: ...Notes ...
