Greasing the Motion
Controls
Service Interval:
Yearly
Grease the operator-presence-control balljoint and
the motion-control bushing for both levers.
Note:
Use an oil drip between the lever brackets to
grease the bushing, located in the pivot tube.
g228034
Figure 40
1.
Operator-presence control
balljoint
2.
Pivot tube
Engine Maintenance
Engine Safety
•
Shut off the engine before checking the oil or
adding oil to the crankcase.
•
Keep your hands, feet, face, clothing, and other
body parts away from the muffler and other hot
surfaces.
Servicing the Air Cleaner
Every 250 hours—Replace the primary air filter
(more often in dirty or dusty conditions).
Every 250 hours—Check the inner air filter
(more often in dirty or dusty conditions).
Every 500 hours—Replace the inner air filter
(more often in dirty or dusty conditions).
Removing the Filters
1.
Disengage the PTO, move the motion-control
levers to the N
EUTRAL
-
LOCK
position, and
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Open the engine guard; refer to
Engine Guard (page 27)
.
4.
Release the retaining clamps on the air cleaner
and pull the air-cleaner cover off the air-cleaner
body (
g026970
Figure 41
1.
Air-cleaner clamps
3.
Primary filter
2.
Air-cleaner cover
4.
Inner filter
5.
Clean the inside of the air-cleaner cover with
compressed air.
6.
Gently slide the primary filter out of the
air-cleaner body (
).
30
Summary of Contents for GrandStand 72504TE
Page 58: ...Schematics g302050 Electrical Schematic 140 1878 Rev A 58 ...
Page 59: ...Notes ...
