Form No. 3399-118 Rev A
Horn Kit
Groundsmaster
®
4000 or 4100 Series Rotary Mower
Model No. 31511
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
Horn
1
Horn switch
1
Horn button (rubber)
1
Bolt (5/16 x 3/4 inch)
1
2
Flange nut (5/16 inch)
1
Install the horn.
3
No parts required
–
Test the horn function.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
1.
Move the machine to a level surface and set the parking
brake.
2.
Shut off the machine and remove the key.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
3.
Disconnect the battery; refer to your
Operator’s Manual
.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3399-118* A
