Engine Maintenance
Engine Safety
•
Shut off the engine before checking the oil or adding oil
to the crankcase.
•
Do not change the governor speed or overspeed the
engine.
Checking the
Engine-Overheat-Warning
System
Service Interval:
Every 500 hours
1
G014437
g014437
Figure 32
1.
Temperature switch
1.
Turn the ignition key to position I.
2.
Disconnect the red/blue wire terminal from the
engine-temperature switch.
3.
Touch the metal terminal of this wire onto a suitable
earth point, ensuring that the metal surfaces make
good contact.
The horn will sound and the engine-coolant-temperature
warning light will illuminate to confirm correct operation. If
the system is not functioning, make repairs before operating
the mower.
Servicing the Air Cleaner
Service Interval:
Before each use or daily
Every 500 hours
Servicing the Primary Air Filter
Check the air cleaner body for damage which could cause an
air leak. Replace if damaged. Check the whole intake system
for leaks, damage, or loose hose clamps.
Service the primary air cleaner filter only when the service
indicator (
) requires it. Changing the air filter before
it is necessary only increases the chance of dirt entering the
engine when the filter is removed.
Important:
Be sure that the cover is seated correctly
and seals with the air cleaner body.
1.
Check the filter-blockage indicator. If the indicator is
red, replace the air filter (
).
G014565
g014565
Figure 33
2.
Before removing the filter, use low-pressure air (40 psi,
clean and dry) to help remove large accumulations of
debris packed between outside of the filter and the
canister.
Note:
Avoid using high-pressure air, which could
force dirt through the filter into the intake tract.
Note:
This cleaning process prevents debris from
migrating into the intake when you remove the filter.
1 2 3
G014566
g014566
Figure 34
1.
Dust boot
3.
Air filter
2.
Dust bowl
3.
Remove the cover from the air-cleaner body.
4.
Remove and replace the filter (
).
Note:
Cleaning a used filter element could damage
the filter media.
5.
Inspect the new filter for shipping damage, checking
the sealing end of the filter and the body.
Note:
Do not use a damaged element.
6.
Insert the new filter by applying pressure to the outer
rim of the element to seat it in the canister.
32
Summary of Contents for Groundsmaster 3400
Page 49: ...Notes...
Page 50: ...Notes...
