Figure 5
Right Side Shown
1. Roll bar
3. Hairpin cotter pin
2. Pin
2. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins (Figure 5).
Note:
If you must lower the roll bar, push
the bar forward to relieve pressure on the
pins, remove the pins, lower the bar slowly,
and secure it with the pins so that it does not
damage the hood.
Step
4
Checking the Tire Pressure
No Parts Required
Procedure
The tires are over inflated for shipping. Therefore,
release some of the air to reduce the pressure. The
correct air pressure is 15 psi (103 kPa) in the rear
tires and 25 psi (172 kPa) in the caster wheels.
19
Summary of Contents for Groundsmaster 7200 Series
Page 9: ...Slope Chart 9 ...
Page 44: ...Figure 39 44 ...
Page 70: ...Schematics Electrical Schematic Rev A 70 ...
Page 71: ...Hydraulic Schematic Rev A 71 ...
