Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first hour
• Check the control cable and adjust it if necessary.
• Check for loose fasteners and tighten them if necessary.
After the first 2 hours
• Change the engine oil.
Before each use or daily
• Check the engine-oil level and add oil if necessary.
Yearly
• Check the control cable and adjust it if necessary.
• Inspect the rotor blades and have an Authorized Service Dealer replace the rotor
blades and scraper if necessary.
• Change the engine oil.
• Service the spark plug and replace it if necessary.
• Check for loose fasteners and tighten them if necessary.
• Have an Authorized Service Dealer inspect the drive belt and replace it if necessary.
Yearly or before storage
• Prepare the machine for storage.
Maintenance Safety
Read the following safety precautions before
performing any maintenance on the machine:
•
Before servicing, adjusting, or cleaning the
machine, shut off the engine and remove the
key. If major repairs are ever needed, contact an
Authorized Service Dealer.
•
Always wear eye protection while performing an
adjustment or repair to protect your eyes from
foreign objects that the machine may throw.
•
Check all fasteners at frequent intervals for proper
tightness to ensure that the machine is in safe
working condition.
•
Do not change the governor settings on the engine.
Purchase only genuine Toro replacement parts
and accessories.
Checking and Adjusting the
Control Cable
Checking the Control Cable
Service Interval:
After the first hour—Check the
control cable and adjust it if
necessary.
Yearly—Check the control cable and adjust it
if necessary.
Move the control bar back toward the handle to
remove the slack in the control cable (
).
g011233
Figure 16
1.
Control bar
2.
1/16 inch to 1/8 inch (2
mm to 3 mm) gap
Note:
Ensure that a 1/16 inch to 1/8 inch (2 mm to
3 mm) gap exists between the control bar and the
handle (
).
Important:
The control cable must contain some
slack when you disengage the control bar for the
rotor blades to stop properly.
12
Summary of Contents for Power Clear 721 R
Page 20: ......
