12.
Install the spark plug and torque it to 20 to 22
ft-lb (27 to 30 N-m).
13.
Connect the wire to the spark plug.
Note:
Ensure that the breather tube is routed
above the spark-plug wire as shown in
g011440
Figure 27
1.
Breather tube
2.
Carburetor drain bolt
14.
Remove the fuel-tank cap.
15.
Install the shroud with the screws that you
removed in step
.
Note:
Ensure that the upper and lower shrouds
fit together in the side grooves.
16.
Install the fuel-tank cap.
17.
Install the chute seal, the discharge chute, and
the discharge-chute handle onto the machine
using the hardware that you removed in step
Note:
The small screw goes through the
small hole in the chute seal at the front of the
discharge-chute opening.
Replacing the Drive Belt
If the drive belt becomes worn, oil-soaked, excessively
cracked, frayed, or otherwise damaged, replace the
belt.
1.
Remove the drive-belt cover by removing the 3
bolts as shown in
g008238
Figure 28
1.
Drive-belt cover
6.
Drive belt
2.
Bolt (3)
7.
Rotor shaft
3.
Rotor-pulley bolt
8.
Brake spring (unhook from
idler arm here)
4.
Curved washer
9.
Idler pulley
5.
Rotor pulley
10.
Engine pulley
2.
Unhook the brake spring from the idler arm to
release the belt tension (
).
3.
Remove the screw and curved washer that
holds the rotor pulley (
).
4.
Remove the rotor pulley and the drive belt
(
).
5.
Install the new drive belt, routing it as shown in
g008317
Figure 29
1.
Brake spring (install on
idler arm here)
3.
Engine pulley
2.
Idler pulley
4.
Rotor pulley
16
Summary of Contents for Power Clear 721 R
Page 20: ......