Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Oval-head bolts
2
Curved washers
2
1
Handle knobs
2
Install the handle.
2
No parts required
–
Install the recoil starter handle.
Discharge chute assembly
1
Screws
2
Washers
2
Locknuts
2
3
Knob
1
Install the discharge chute assembly.
4
Bottle of engine oil
1
Fill the engine with oil.
5
No parts required
–
Adjust the control cable.
1
Installing the Handle
Parts needed for this procedure:
2
Oval-head bolts
2
Curved washers
2
Handle knobs
Procedure
1.
Position the ends of the upper handle on the inside of
the lower handle and align the holes.
2.
Insert the oval-head bolts into the aligned holes, with
the bolt heads on the outside of the handle (Figure 4).
Figure 4
1.
Oval-head bolt (2)
2.
Curved washers and
handle knobs
3.
Install the curved washers and the handle knobs on the
oval-head bolts on the inside of the handle (Figure 4)
and
tighten the knobs securely
.
Important:
Ensure that the cable is routed to the
outside of the handle.
5
Summary of Contents for Powerlite 38273
Page 18: ...Notes 18...
