Adjusting the Control Cable
1.
Slide up the spring cover and unhook the spring from
the adjuster link (Figure 10).
Figure 10
1.
Adjuster link
3.
Spring cover
2.
Z-fitting
4.
Unhook the spring here.
Note:
You can pull up the adjuster link and cable to
make unhooking the spring easier.
2.
Move the Z-fitting to a higher or lower hole on the
adjuster link as needed to obtain the 1/16-inch to
1/8-inch (2 mm to 3 mm) gap between the control bar
and the handle (Figure 10).
Note:
Moving the Z-fitting higher decreases the gap
between the control bar and the handle; moving it
lower increases the gap.
3.
Hook the spring to the adjuster link and slide the spring
cover over the adjuster link.
4.
Check the adjustment; refer to Checking the Control
Cable.
Note:
The belt may slip (squeal) in wet conditions;
to dry out the drive system, start the rotor and run it
without a load for 30 seconds.
Product Overview
Figure 11
1.
Control bar
6.
Chute deflector trigger
2.
Recoil start handle
7.
Chute deflector
3.
Spring cover
8.
Discharge chute
4.
Fuel tank cap
9.
Rotor blades
5.
Chute handle
0
Figure 12
1.
Spark plug
5.
Primer
2.
Oil fill cap
6.
Ignition key
3.
Oil drain plug
7.
Electric-start button
(model 38283 only)
4.
Choke lever
8.
Plug-in for electric start
(model 38283 only)
8
Summary of Contents for Powerlite 38273
Page 18: ...Notes 18...
