3-5
WPM Drive Systems Manual
22” FRONT WHEEL DRIVE MODELS
1. Block the front of the mower up. There are two
screws that secure the belt cover to the housing.
They are accessed from the bottom (Fig. 042).
Fig 042
MVC-482
2. Slip the belt out between the transmission pulley and
belt guide.
3. Grip the axle with locking pliers and remove the
locknut on the transmission pulley (Fig. 043)
Fig 043
MVC-486
Fig 044
MVC-472
4. Remove the nut, washer, transmission pulley halves,
and spacer.
5. Remove the belt guide.
6. Remove both front wheels; note there is a washer
between the wheel and wheel cover.
7. To remove the wheel pinions, remove the klip ring
and thrust washer. The pinion will now slide off the
axle (Fig. 044).
Note: The spring-loaded drive key is under the
pinion.
SINGLE SPEED BEVEL GEAR TRANSMISSION
Remove Transmission
A
A
A. Key
B. Wheel
cover
B
8. Remove the wheel cover.
Summary of Contents for Recycler 20012
