3-18
WPM Drive Systems Manual
SINGLE SPEED BEVEL GEAR TRANSMISSION
Fig 087
MVC-472
6. Coat the axle, key, and spring with #2 molybendum
disulfi de grease or anti-seize compound before
installing the pinion (Fig. 087).
7. The wheel pinion is marked with an R and L for right
and left. Identify right and left from the operator’s
position (Fig. 088). On the right side, the R should
face outward. The letter L should face outward on
the left side. If the wheel pinions are reversed, the
wheels will not drive.
Fig 088
MVC-474
R
Note: See Chapter 5 for more information on Wheel
Clutches.
Summary of Contents for Recycler 20012
