131-0894
Traction Adjustment
1.
Attention; read the
Operator's Manual
—1) Loosen the
knob by turning it counterclockwise; 2) Pull the cable(s)
away from the engine to decrease the traction, or push
the cable(s) toward the engine to increase the traction; 3)
Tighten the knob by turning it clockwise.
131–4514
1.
Warning—read the
Operator's Manual
.
2.
Cutting/dismemberment hazard of hand or foot, mower
blade—stay away from moving parts; keep all guards and
shields in place.
3.
Cutting/dismemberment hazard of hand or foot, mower
blade—disconnect the spark-plug wire and read the
instructions before servicing or performing maintenance.
4.
Thrown object hazard—keep bystanders a safe distance
from the machine; stop the engine before leaving the
operating position; pick up any debris before mowing.
5.
Cutting/dismemberment hazard of hand or foot, mower
blade—do not operate up and down slopes; operate side to
side on slopes; look behind you when backing up.
Setup
Important:
Remove and discard the protective plastic
sheet that covers the engine.
1
Installing the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when folding or
unfolding the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1.
Remove the handle knobs from the machine (
).
Important:
Route the cables to the outside of the
handle knobs as you install the handle.
Figure 3
2.
Install the handle on the bolts on the machine (
).
4
Summary of Contents for Recycler 20332
