Important:
When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the bag-on-demand
lever is in the Bagging position, move the lever to the
Recycling position before recycling the clippings; refer to
Operating the Bag-on-Demand Lever (page 12)
. If the
side-discharge chute is on the machine, remove it before
recycling the clippings; refer to
.
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
If the side-discharge chute is on the machine, remove it before
bagging the clippings; refer to
. If the bag-on-demand lever is in the
Recycling position, move it to the Bagging position; refer to
Operating the Bag-on-Demand Lever (page 12)
.
Installing the Grass Bag
1.
Raise and hold up the rear deflector (
).
Figure 21
1.
Rear deflector
3.
Grass-bag pin (2)
2.
Notches (2)
2.
Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle (
3.
Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
.
Operating the Bag-on-Demand Lever
The bag-on-demand feature allows you to either collect or
recycle grass and leaf clippings while the grass bag is attached
to the machine.
•
For bagging the grass and leaf clippings, press the button
on the bag-on-demand lever and move the lever forward
until the button on the lever pops up (
).
Figure 22
1.
Bag-on-demand lever (in bagging position)
•
For recycling the grass and leaf clippings, press the button
on the lever and move the lever rearward until the button
on the lever pops up.
Important:
For proper operation, remove any grass
clippings and debris from the bag-on-demand door and
the surrounding opening (
) before you move
the bag-on-demand lever from 1 position to another.
Figure 23
1.
Clean here
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the grass bag is on the machine and the bag-on-demand
lever is in the Bagging position, move the lever to the
Recycling position; refer to
.
12
Summary of Contents for Recycler 20334
Page 22: ...Notes 22 ...
Page 23: ...Notes 23 ...
