10
1
2
3
6
5
4
m-4798
Figure 6
1.
Bag cover
2.
Top frame bar
3.
Bag cover snap fitting (3)
4.
Top channel (2)
5.
Side channel (2)
6.
Bag base snap fitting (4)
4. Insert the two side channels and two top channels of
the grass bag onto the grass bag frame as shown in
Figure 6.
Note: To insert the channels onto the grass bag frame,
start on one end of the channel and push it onto the frame.
5. Snap the bottom frame bar into the four snap fittings
on the bag base as shown in Figure 6.
Note: Make sure the sides of the bag base are inside the
bag frame as shown in Figure 7.
Figure 7
Before Starting
Filling the Crankcase with Oil
The crankcase can hold 22 ounces (0.65 liters) of oil. Use
only high-quality, SAE 30 or 10W30 weight detergent oil
that has the American Petroleum Institute (API) “service
classification” — SF, SG, SH, or SJ.
Before each use, make sure that the oil level is between
the Add and the Full marks on the dipstick (Fig. 8).
1
2
m-3665/284
Figure 8
1.
Oil fill tube
2.
Dipstick
To add oil:
1. Move the lawn mower to a level surface.
2. Clean around the dipstick (Fig. 8).
3. Remove the dipstick by rotating the cap
counterclockwise 1/4 turn and pulling it out.
4. Wipe the dipstick clean with a clean cloth.
5. Fully insert the dipstick into the filler neck, then
remove it.
Note: To ensure an accurate oil level reading, you must
fully install the dipstick.
6. Read the oil level on the dipstick (Fig. 8).
7. If the oil level reading is below the Add mark on the
dipstick, slowly pour only enough oil into the filler
hole to raise the oil level to the Full mark on the
dipstick.
IMPORTANT: Do not overfill the crankcase with oil
and run the engine; engine damage will result. Drain
the excess oil until the oil level on the dipstick reads
Full.
Summary of Contents for Recycler 20826
Page 28: ......
