Note:
The water will splash into the path of the blade,
cleaning out the clippings.
Figure 37
2.
When no more clippings come out, stop the water and
move the machine to a dry area.
3.
Run the engine for a few minutes to dry the housing
to prevent it from rusting.
Storage
Preparing the Machine for
Storage
WARNING
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the machine in an enclosure near
an open flame.
•
Allow the engine to cool before storing it.
1.
On the last refueling of the year, add fuel stabilizer to
the fuel as directed by the engine manufacturer.
2.
Run the machine until the engine stops from running
out of fuel.
3.
Prime the engine and start it again.
4.
Allow the engine to run until it stops. When you can
no longer start the engine, it is sufficiently dry.
5.
Disconnect the wire from the spark plug.
6.
Remove the spark plug, add 30 ml (1 oz) of oil through
the spark plug hole, and pull the starter rope slowly
several times to distribute oil throughout the cylinder
to prevent cylinder corrosion during the off-season.
7.
Loosely install the spark plug.
8.
Tighten all nuts, bolts, and screws.
9.
Charge the battery for 24 hours, then unplug the
battery charger and store the machine in an unheated
area. If you must store the machine in a heated area,
you must charge the battery every 90 days.
Folding the Handle
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when folding or
unfolding the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1.
Loosen the handle knobs until you can move the upper
handle freely (Figure 38).
16
Summary of Contents for Recycler 20990
Page 18: ...Notes 18 ...
