g024432
Figure 8
1.
Full
3.
Low
2.
High
3.
Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
4.
Wait about 3 minutes for the oil to settle in the engine.
5.
Wipe the dipstick clean with a clean cloth.
6.
Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
7.
Read the oil level on the dipstick (
).
•
If the oil level on the dipstick is too low, carefully
pour a small amount of oil into the oil-fill tube,
wait 3 minutes, and repeat steps
through
until
the oil level on the dipstick is at the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil level on the dipstick is
at the correct level; refer to
.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
Important:
Change the engine oil after
the first 5 operating hours; change it yearly
thereafter. Refer to
(page 16)
.
8.
Install the dipstick securely.
4
Assembling the Grass Bag
No Parts Required
Procedure
1.
Slip the grass bag over the frame as shown in
.
1
2
3
g027120
g027120
Figure 9
1.
Handle
3.
Grass bag
2.
Frame
Note:
Do not slip the bag over the handle (
).
2.
Hook the bottom channel of the bag onto the bottom
of the frame (
6
Summary of Contents for Recyler 20379
Page 20: ...Notes ...
Page 42: ...Notas ...
