1.
Park the machine on a level surface, shut off the
engine, set the parking brake, and remove the
key from the ignition switch.
2.
Open the hood.
3.
Remove the dipstick, wipe it clean, and install
it (
g003950
Figure 76
1.
Dipstick
4.
Remove the dipstick and check the oil level on
the dipstick.
Note:
The oil level should be up to the Full
mark.
5.
If the oil level is below the Full mark, remove the
fill cap (
), and add oil until the level
reaches the Full mark on dipstick.
g004134
Figure 77
1.
Oil-fill cap
Important:
Do not overfill. Be sure to keep
the engine-oil level between the upper and
lower limits on the oil gauge. Engine failure
may occur as a result of over filling or under
filling the engine oil.
6.
Install the oil-fill cap and close the hood.
Servicing the Engine Oil
and Filter
Change the engine oil and filter initially after the first
50 hours of operation and every 150 hours thereafter.
1.
Remove the drain plug (
) and let the
oil flow into a drain pan.
g003970
Figure 78
1.
Oil drain plug
2.
When the oil stops, install the drain plug.
45
Summary of Contents for Reelmaster 5610
Page 68: ......