g003320
Figure 5
1.
Counterweight
Positioning the Turf Compensating
Spring and Installing the Hose
Guide
Cutting Units 4
g375671
Figure 6
1.
Cutting unit 1
5.
Cutting unit 5
2.
Cutting unit 2
6.
Reel motor
3.
Cutting unit 3
7.
Weight
4.
Cutting unit 4
1.
If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(
).
g375689
Figure 7
1.
Hairpin
2.
Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame (
).
g375690
Figure 8
1.
Carriage bolt (3/8 x 1-1/4
inches)
3.
Flange locknut (3/8 inch)
2.
Turf-compensator bracket
3.
Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit (
Note:
Do not remove the flange serrated nut
from the capscrew.
12
Summary of Contents for Reelmaster 5610
Page 68: ......