filled the reservoir with an alternative fluid,
change the hydraulic fluid.
If the fluid becomes contaminated, contact your Toro
Distributor because the system must be flushed.
Contaminated fluid looks milky or black when
compared to clean fluid.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 40)
.
2.
Place a large drain pan under the straight fitting
(
) of the hydraulic tank.
g377036
Figure 105
1.
Straight fitting (hydraulic
tank)
3.
Return filter
2.
Hose (case drain)
3.
Disconnect the case-drain hose from the straight
fitting, and allow the tank to drain.
4.
When hydraulic fluid stops draining from the
tank, install the drain hose.
5.
Fill the tank with the specified hydraulic fluid;
refer to
Hydraulic Fluid Specifications (page 58)
and
Hydraulic Fluid Capacity (page 60)
.
Important:
Use only the hydraulic fluids
specified. Other fluids could cause system
damage.
6.
Install the tank cap.
7.
Start the engine, and use all the hydraulic
controls to distribute hydraulic fluid throughout
the system.
8.
Check for hydraulic-fluid leaks; refer to
.
9.
Check the level; refer to
Hydraulic-Fluid Level (page 58)
Cutting Unit System
Maintenance
Blade Safety
A worn or damaged blade or bedknife can break, and
a piece could be thrown toward you or bystanders,
resulting in serious personal injury or death.
•
Inspect the blades and bedknives periodically for
excessive wear or damage.
•
Use care when checking the blades. Wear gloves
and use caution when servicing them. Only
replace or backlap the blades and bedknives;
never straighten or weld them.
•
On machines with multiple cutting units, take care
when rotating a cutting unit; it can cause the reels
in the other cutting units to rotate.
Checking the
Reel-to-Bedknife Contact
Service Interval:
Before each use or daily
Check the reel-to-bedknife contact, regardless of
whether the quality of cut had previously been
acceptable. There must be light contact across the full
length of the reel and the bedknife (refer to Adjusting
the Reel to Bedknife in the cutting unit
Operator's
Manual
).
Backlapping the Cutting
Units
WARNING
Contact with the cutting units or other moving
parts can result in personal injury.
•
Keep your fingers, hands, and clothing
away from the cutting units and other
moving parts.
•
Never attempt to turn the cutting units by
hand or foot while the engine is running.
Note:
Additional instructions and procedures on
backlapping are available in the Toro Reel Mower
Basics (with sharpening guidelines), Form 09168SL.
Preparing the Machine
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 40)
.
2.
Press the Enable/Disable switch to D
ISABLE
position.
61
Summary of Contents for Reelmaster 5610
Page 68: ......